|
|
PM3387 S/UNI® 1xGE
Single Port Gigabit Ethernet Controller
Documents
> Are you seeing all
your results?
If you are a PMC-Sierra Customer or Partner you may have permission to see additional results.
Please log in to display additional results. |
Features
- One port full-duplex Gigabit Ethernet Controller with an industry standard POS-PHY Level 3 system interface.
- Provides direct connection to optics.
- Connection to copper Gigabit Ethernet physical layer devices via GMII interface.
- Incorporates single SERDES, compatible to IEEE 802.3 1998 PMA physical layer specification.
- Supports single IEEE 802.3 -1998 GMII/TBI interface for connection to copper Gigabit Ethernet physical layer device.
- Provides single standard IEEE 802.3 Gigabit Ethernet MAC for frame verification.
- Provides on-chip data recovery and clock synthesis.
|
- Provides eight unicast exact-match address filters to filter frames based on DA, SA, or VID.
- Each address filter can indicate whether to accept or discard based on a match.
- Provides 64-group multicast address filter.
- Internal 16 kbyte TX and 64 kbyte RX FIFOs to accommodate system latencies.
- SATURN® compatible interface for Packet-Over-SONET Physical Layer and Link Layer devices Level 3 (POS-PHY Level 3 system interface).
- Line side loopback for system level diagnostic capability.
- 16 bit generic microprocessor interface for device initialization, control, register and per port statistics access.
|
GIGABIT ETHERNET MAC
- Verifies frame integrity (FCS and length checks).
- Errored frames can be filtered or passed to a higher layer device.
- Automatic Base Page Autonegotiation, extended Autonegotiation (Next Page) supported via host.
- Egress Ethernet frame encapsulation (pad to minimum size, add preamble, IFG and CRC generation).
- Supports Ethernet 2.0, IEEE 802.3 LLC and IEEE 802.3 SNAP/LLC encoding formats, and VLAN tagged frames.
|
- Minimum frame size 64 bytes. Supports jumbo frames up to 9.6 kbytes.
- Supports big endian data formats.
- Programmable inter-packet gap (IPG).
- Loopback for diagnostic capability through GMAC.
|
FLOW CONTROL
- Option to support IEEE 802.3-1998 flow control at each Ethernet port.
- Programmable watermarks for full/empty FIFO conditions.
- Automatic generation of pause frames based on FIFO fill levels.
|
- Upper layer device can flow control Ethernet ports using side-band or host signaling to cause generation of a Pause frame.
- Provides per-port side-band Pause state indication for upstream devices.
- Loss-less flow control on all valid frames up to 9.6 kbytes.
|
STATISTICS
- 40 bit counters are used to ensure rollover compliance with IEEE 802.3-1998.
- Minimum 58 minutes before rollover.
|
- Provides statistic counters to support SNMP and RMON implementations.
|
POS-PHY LEVEL 3 SYSTEM INTERFACE
- Standard OC-48 bandwidth Packet/Cell interface.
- Compatible with PMC-Sierra devices supporting POS-PHY Level 3, including:
- PM5381 S/UNI 2488 ATM and POS physical layer device.
- PM5358 S/UNI 4x622 single channel OC-48c device with integrated analog.
- PM7390 S/UNI MACH 48 multi-service access device for channelized interfaces.
|
- PM5382 S/UNI 16x155 sixteen channel OC-3c framer with integrated analog and POS-PHY Level 3 and UTOPIA Level 3 interface.
- POS-PHY Level 3 provides connection to upper layer device at data rates up to 2,400 Mbit/s.
- Supports point-to-point POS-PHY Level 3 applications.
- 32 bit data at 104 MHz.
- In-band addressing for dual port PHY support.
|
PACKAGING
- Packaged in a 352-pin UBGA.
- Implemented in low power 1.8 V CMOS technology with 3.3 V compatible I/O.
|
- Industrial temperature range (-40 °C to +85 °C).
- Provides a standard 5 signal P1149.1 JTAG test port for boundary scan board test purposes.
|
DEVICE INTERNETWORKING
- Other PMC-Sierra devices that implement the POS-PHY Level 3 interface include:
- PM3386: SUNI 2xGE - Dual gigabit ethernet controller.
- PM3387: SUNI 1xGE - Single gigabit ethernet controller.
- PM5354: SUNI MULTI 2x12 - Multi-rate OC-12x/OC-3c ATM and POS.
- PM5358: SUNI 4x622 - Quad channel OC-12c ATM and POS.
- PM5360: SUNI MULTI 48 - Multi-rate OC-48c/OC-12c/OC-3c ATM and POS.
- PM5379: SUNI 4x155 - Quad channel OC-3c ATM and POS.
- PM5380: SUNI 8x155 - Eight channel OC-3c ATM and POS.
- PM5381: SUNI 2488 - Single channel OC-48c ATM and POS.
- PM5382: SUNI 16x155 - Sixteen channel OC-3c ATM and POS.
- PM5383: SUNI 12xJET - Twelve channel DS3 ATM and POS.
- PM5386: SUNI 4xJET - Quad channel DS3 ATM and POS.
- PM7325: SUNI ATLAS 3200 - 2.488G ATM layer solution.
- PM7390: SUNI MACH 48 - Multiservice access device for channelized interfaces.
|
Applications
- POS-PHY Level 3 provides consistent system interface for multiple PHY types.
- Edge and Core Routers.
- Multi-Service Switches.
- SONET/SDH Transport Equipment.
- Ethernet over SONET uplinks.
- Gigabit Ethernet ports for Optical Cross Connects.
|
- Gigabit Ethernet Access IADs.
- Gigabit Ethernet Test Equipment.
- IP DSLAM Uplinks
- CMTS Uplinks
- BTS/BSC Uplinks
|
|
PM3387 S/UNI 1xGE Ethernet Controller Short Form Data Sheet [73 KB] PMC-2031964 
PM3386 S/UNI-2xGE and PM3387 S/UNI-1xGE Device Driver [161 kB] PMC-2010089 
Boundary Scan Description Language (BSDL) Source Code for the PM3386 S/UNI 2XGE Device PMC-2010137